Quiz-summary
0 of 10 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
Information
EPA 608 Free Practice Exam 3: Type 3
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 10 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Answered
- Review
-
Question 1 of 10
1. Question
1 pointsThe EPA requires that all comfort cooling systems with more than 50lb of refrigerant be repaired when the annual leak rate exceeds ______ :
Correct
Incorrect
-
Question 2 of 10
2. Question
1 pointsThe easiest way to leak test a low pressure system is to add warm water over the coil to raise the pressure to _______:
Correct
Incorrect
-
Question 3 of 10
3. Question
1 pointsWhen a electronic leak detector is used to test a water box for leaks, test at the drain valve after the water has been removed:
Correct
Incorrect
-
Question 4 of 10
4. Question
1 pointsA purge unit is used on high pressure chillers to remove the non condensables from the system:
Correct
Incorrect
-
Question 5 of 10
5. Question
1 pointsTo prevent a _____ pressure system from freezing during evacuation, water is commonly run through the chiller tubes:
Correct
Incorrect
-
Question 6 of 10
6. Question
1 pointsAbsorption chillers have a _______ Coefficient of Performance in cooling (COPc)
Correct
Incorrect
-
Question 7 of 10
7. Question
1 pointsWhen the refrigerant flow is substantially reduced once the system is evacuated, the motor could:
Correct
Incorrect
-
Question 8 of 10
8. Question
1 pointsOpen-drive compressors are typically ______ compressors
Correct
Incorrect
-
Question 9 of 10
9. Question
1 pointsIf a liquid receiver is used, it is located downstream of the ______
Correct
Incorrect
-
Question 10 of 10
10. Question
1 pointsThe air ducts are smaller and less expensive to install compared to water lines leading to each section of the building or refrigerant lines to individual sections
Correct
Incorrect